D6000 - D6200 Series Information
View all models
G.M. International new universal mount Galvanic
Isolators provide the most simple and cost effective
means of implementing isolation in non Hazardous applications.
General Features
- More than 25 modules suitable for SIL 2 applications according to IEC 61508, IEC 61511.
- Independent power supply circuit for each channel.
- Double units are equivalent to two single units
because of the absence of common circuitry.
- Single channel versions available if required,
to provide single loop integrity on Emergency Shut
Down and Fire & Gas applications.
- Configuration components are easily accessed by removing cover.
- DIP switch configurability for easy field setup.
- LED indication for power, signal status and line fault conditions.
- Modules accept DC power supply over a wide range for 24 Vdc (20-30 Vdc) applications.
- Wide operating temperature range: -40 to +60/+70 °C.
- Certified for Offshore and Marine applications.
High performance
- High signal transfer accuracy and repeatability.
- Advanced circuitry provides very low heat
dissipation, ensuring modules run cool despite their
high density and functionality.
- SMD manufacturing to maximize lifetime and enhance reliability.
- Complete absence of electrolytic capacitors ensures
minimum 20 years lifetime.
 ^ 6 mm per channel + low power consumption
High packing density
- DIN-Rail 35 mm Top Hat mounting.
- Ultra slim 2 channels 12 mm wide DIN-Rail and
Termination Board mounting modules.
- Power and fault on bus connectors.
- 6 mm per channel means 50% space reduction.
|
Wide functionality
- Wide range of digital and analog I/O.
- SIL 3 Safety Relay contacts rated for 4 A or 10 A for direct switching of high loads.
- Three port galvanic isolation to eliminate noise and ground loop problems.
- Line fault alarm detects open or short circuit of field cables.
- Optional power bus DIN-Rail connector.
- Standard Termination Board, custom connectors for integration into customized Boards.
- EMC Compatibility to EN61000-6-2, EN61000-6-4, EN61326-1, EN61326-3-1 for safety system.
Certifications and Approvals
D6000 Series is applied for:
- European Directives for EMC.
- SIL 2 modules according standards IEC61508 and IEC61511
|
